CTP-1000C CT PT tester is a new generation of innovative CT and PT tester developed by our company. It adopts high-performance DSP, FPGA and advanced manufacturing technology to ensure stable and reliable product performance, complete function, high degree of automation and high test efficiency. It is a professional test instrument for transformer in the power industry.

Ctp-1000c ctpt tester can be used in the fllowing situations:

1. Electric power research institute conducts transformer calibration;

2. The transformer manufacturer shall carry out factory calibration;

3. Preventive test of power sector;

4. Handover test of engineering units and panel and cabinet enterprises.

When using ctp-1000c ctpt tester, pay attention to the following safety precautions to avoid personal injury and damage to this

product or any other products connected with it.

1. As a safety measure, the instrument is equipped with a protective grounding terminal. Before the test, the grounding terminal on the side of the device shall be reliably grounded.

2. Prevent fling: do not place the instrument on an unstable platform or desktop to prevent the instrument from flling and damage.

3. Use appropriate power cord: use 220VAC, 50 / 60Hz power cord with current of 10a and above.

4. Ensure good heat dissipation: the fans and ventilation holes on the side of the instrument are set for ventilation and heat dissipation. Do not block them.

5. Prevent short circuit: do not let any foreign matter fall into the chassis to avoid short circuit.

6. Connect and disconnect correctly: do not connect or disconnect test leads while the device is being tested.